Manual Sewage Pump, 2HP, 25' cord, 440/480V, 3-Phase

Click Image for Gallery

The LEH204M2-2 from Liberty Pumps is a Manual Sewage Pump, 2HP, 25' cord, 440/480V, 3-Phase. The Liberty LEH204M2 has an 83' shut-off head and a 2" FNPT flanged discharge. These Liberty high head sewage pumps are intended to be run using an approved liquid level control or approved motor control with correct rating that matches motor input in full load amperes. The Liberty submersible high head sewage pump features 2-vane, semi-open impellers that allow passage of 2" solids. 3-Phase Liberty high-head submersible sewage pumps require panel for automatic operation. See sewage accessories literature for complete information on all simplex and duplex controls. Check three phase pumps for proper rotation prior to installing pump(s) in the basin. To change rotation, reverse any two of the three power leads to the high head sewage pump.

This Liberty high head sewage pump is constructed of heavy cast iron with a tough epoxy powder coat finish and stainless steel fasteners for years of trouble-free performance. The Liberty LEH204M2 high head sewage pumps must only be used in applications with a minimum of 20'.When the high head sewage pump shuts off, at least 6" of fluid must be left in the basin so the impeller remains submerged. Separate approved pump control device or panel is required for automatic operation.

Features:

83' Maximum TDH
2HP Oil-filled, hermetically sealed motors
Rugged 2 vane, closed cast iron impellers
Cast iron housing and volute with all stainless fasteners
416 stainless steel rotor shaft
Built-in thermal protection on single phase models
Permanently lubricated upper and lower ball bearings
Dual shaft seals
Quick-disconnect 25' standard power cord allows replacement of cord in seconds without breaking seals to motor

Technical Specifications: