Manual Sewage Pump, 1-1/2HP, 25' cord, 440/480V, 3-Phase

Manual Sewage Pump, 1-1/2HP, 25' cord, 440/480V, 3-Phase
Manual Sewage Pump, 1-1/2HP, 25' cord, 440/480V, 3-Phase QR Code
QR-Code
Product Code: LEH154M3-2 UPC: 671812115802

MPN: LEH154M3-2

Weight:92.00 lb

Usually ships: 7-10 business days
$1,198.40

* Country:
* State:
* ZIP:
Qty: Add to Cart

Have any questions?
Contact us at 1-800-246-9552

The LEH154M3-2 from Liberty Pumps is a Manual Sewage Pump, 1-1/2HP, 25' cord, 440/480V, 3-Phase. The Liberty LEH154M3 has a 70' shut-off head and a 3" FNPT flanged discharge. The Liberty submersible high head sewage pump features 2-vane, semi-open impellers that allow passage of 2" solids. This Liberty high head sewage pump is constructed of heavy cast iron with a tough epoxy powder coat finish and stainless steel fasteners for years of trouble-free performance.

These Liberty high head sewage pumps are intended to be run using an approved liquid level control or approved motor control with a correct rating that matches motor input in full load amperes. When the high head sewage pump shuts off, at least 6" of fluid must be left in the basin so the impeller remains submerged. Separate approved pump control device or panel is required for automatic operation. The Liberty LEH154M3 high head sewage pumps must only be used in applications with a minimum of 20'. 3-Phase Liberty high head sewage pumps require panel for automatic operation. See sewage accessories literature for complete information on all simplex and duplex controls. Check three phase pumps for proper rotation prior to installing pump(s) in basin.


Features:

  • 70' Maximum TDH
  • Rugged 2 vane, semi-open cast iron impellers
  • Cast iron housings and volute with all stainless and brass fasteners
  • 416 stainless steel rotor shaft
  • Oil-filled, hermetically sealed motors
  • Built-in thermal protection on single phase models
  • Permanently lubricated upper and lower ball bearings
  • Unitized shaft seals
  • Single float mechanical level control with series plug for manual bypass operation-standard on single-phase automatic models
  • Adjustable pumping range
  • Quick-disconnect 25' standard power cord allows replacement of cord in seconds without breaking seals to motor
     

Technical Specifications:

  • Horsepower: 1-1/2HP
  • Cord length: 25'
  • Discharge: 3" FNPT Flanged
  • Solids Handling: up to 2"
  • Shut-off Head: 70'
  • Voltage: 440-480V
  • Amps: 5.3
  • Hertz: 60 Hz
  • Phase: 3
  • RPM: 3450
  • Maximum fluid temperature: 140°F
  • Height: 21"
  • Width: 13"
  • Weight: 92 lbs.
  • Minimum basin diameter: 18"
  • Minimum basin depth: 24"
     

Warranty: 

  • 3 years manufacturer's warranty
Product Specs
Cord Length:25'
Discharge:3" FNPT
Horse Power:1-1/2
Shutoff Head (ft.):70 ft
Type:Manual
Voltage:480v
There are no reviews for this product.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Loading...
Loading...
Loading...