Category

4" Innoflue SW Tee Cap w/ Drain

4" Innoflue SW Tee Cap w/ Drain
4" Innoflue SW Tee Cap w/ Drain QR Code
QR-Code
Views: 5054 Model: ISTCD04

MPN: ISTCD04

Availability:1

Weight:1.00 lb

Dimensions (L x W x H ): 5.50 x 5.50 x 6.00

Usually ships: 1 business day(s)
$78.95
Qty: Add to Cart

ORDERS OVER $99 SHIP FREE

Have any questions?
Contact us at 1-800-246-9552

The ISTCD04 from Centrotherm is a Tee Cap w/ Drain for use with 4” Innoflue SW vent pipes. This tee caps allows for vertical condensate drainage in a Innoflue SW (Single Wall) vent pipe system. Drain OD is 1.26". Requires IANS04 connector ring (not included). Install using IACE50 Centrocerin.

Features:

  • Innoflue SW (Single Wall) is the only polymer vent system on the market listed to UL 1738;
  • Accepted and approved by over 50 North Amercian manufacturers of boilers, water heaters and furnaces;
  • Suitable for natural gas, propane and fuel-oil condensing and non-condensing (flue temp. below 248°F) appliances;
  • All parts (pipe, fittings, etc. - both black and grey) are UV resistant and suitable for indoor or outdoor installation;
  • Requires no primer/glue and does not leach chloride like PVC & CPVC;
  • Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles;
  • Industry-leading 2mm wall thickness;
  • Built-in gasket allows for adhesive-free installation which can be adjusted at any time;
  • May be installed through a wall, chimney, chase or between joists;
  • Lightweight, requires minimal support;
  • Made in the USA from environmentally-friendly PolyPropylene (PP).
There are no reviews for this product.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Loading...
Loading...
Loading...