3" Innoflue SW Horizontal Condensate Drain Tee

Click Image for Gallery

The ISHDT03 from Centrotherm is a Horizontal Condensate Drain Tee for 3” Innoflue SW pipe. Designed to drain condensate from 3" Innoflue SW (Single Wall) vent system. Installs horizontally in a pipe section closest to the appliance. Drain size is 1.26" OD. Use with IANS03 connector ring (required) and IACE50 Centrocerin (optional).

Features:

Innoflue SW (Single Wall) is the only polymer vent system on the market listed to UL 1738;
Accepted and approved by over 50 North Amercian manufacturers of boilers, water heaters and furnaces;
Suitable for natural gas, propane and fuel-oil condensing and non-condensing (flue temp. below 248°F) appliances;
All parts (pipe, fittings, etc. - both black and grey) are UV resistant and suitable for indoor or outdoor installation;
Requires no primer/glue and does not leach chloride like PVC & CPVC;
Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles;
Industry-leading 2mm wall thickness;
Built-in gasket allows for adhesive-free installation which can be adjusted at any time;
May be installed through a wall, chimney, chase or between joists;
Lightweight, requires minimal support;
Made in the USA from environmentally-friendly PolyPropylene (PP).